"Good" Level Car and Truck Lifts

Product Description Tuxedo LR-26-PAD: a 6,000 lb low-rise you can actually drive a low car onto The number that decides whether a low-rise lif...

An alignment rack, not a four-post with turnplate holes cut in it What separates the Tuxedo FP14KA-C from an ordinary four-post is the hardwar...

BendPak HDSO14AX: an open-front alignment lift built around 10.5" cable sheaves Four-post lifts do not usually fail at the columns. They fail ...

BendPak HDS-40 Four-Post Heavy-Duty Lift Buy a 40,000 lb lift and you are really buying its failure behaviour, because that is the part you wi...

BendPak HDS-27X Four-Post Heavy-Duty Lift, Extended Runways The HDS-27X is the one lift in this series whose runways can be set at two differe...

HDS-27: four cables, each rated to break at 14,000 lbs When a 27,000 lbs refuse truck is in the air, the entire question is the cable. The HDS...

HDS-18EA: aligning a truck without ever taking the weight off its suspension The reason the HDS-18EA is an alignment lift rather than a four-p...

HDS-18E: buying 9 tons of lift because 9 tons is what you lift Most heavy-duty four-post lifts are sold by pointing at the biggest number in t...

BendPak HDS-14LSX 14,000 lb Four-Post Alignment Lift The parts of a four-post lift that decide how long it lasts are the ones nobody photograp...

BendPak HD-9AE 9,000 lb. 4 Post Alignment Lift An alignment lift built as one, not converted into one Plenty of four-post lifts can be made to...

74.4 in. long, and none of it above the floor The BendPak P-9000LTF is the flush-mount member of this low-rise family, and the number that exp...

Four published lock heights, so the car sits where the job wants it A low-rise lift that only goes up and down is a jack with ambitions. The B...

BendPak MDS-6LP: three published working heights, not just "up" A mid-rise scissor lift is bought to put a car at the height that suits the jo...

BendPak LR-60 Low-Rise Lift The LR-60 is the fixed-position member of BendPak's low-rise family: a 6,000 lb scissor lift, 70.5" (1,791 mm) acr...

Four Parallelogram Support Bars Per Platform — Which Is How a Low-Rise Lift Reaches 10,000 lbs Low-rise lifts are usually the compromise you ...

The number that decides your car: minimum wheelbase, published four ways Rated capacity on a four-post lift assumes the vehicle is long enough...

AMGO DX-12A: a 12,000 lb Alignment Scissor With a 9,000 lb Jack Built In The specification that separates the DX-12A from an ordinary alignmen...

Katool KT-H115Z: an 11,000 lb two-post lift with a load test on the page Almost every lift sheet in this category says the structure was "test...