BENDPAK Car Lifts

BendPak 12AP-SRT: a 12,000 lb two-post lift that deliberately stops at working height Almost every two-post lift is sold on how far up it goes...

BendPak 10APX-181: a forged-steel arm restraint rated to hold 2000 pounds sideways The most likely thing to go wrong on a two-post lift is not...

BendPak 10APX: arms that retract to 22 in. and reach out to 57 in. Two-post lifts are compared on capacity, and capacity is rarely the thing t...

A 93.5 in. post, so a full-capacity two-post lift fits a garage that cannot take one Every argument about two-post lifts eventually comes back...

HD-973PX: the triple stacker built around long vehicles, not average ones The HD-973PX is the version of this three-level parking lift you buy...

HD-973P: a three-car stacker with nothing sticking up above it Most triple-stack parking systems are ruled out by the building, not the budget...

BendPak PL-6KT Triple Independent Platform Parking Lift Most parking lifts leave the car underneath sitting below a pair of open runways, whic...

It uses no motor power at all on the way down The PL-6000DC lowers on gravity. The platform's own weight drives the descent through the hydrau...

PL-12000DPS: the triple-stack idea, sized for a garage with an ordinary roof Every stacking parking lift asks the same question first, and it ...

PL-12000DP: two parking platforms that rise and lower independently The most useful fact about the PL-12000DP is sitting halfway down the manu...

BendPak PCL-18B-8 — Eight Columns, or Two Independent Fours The argument for eight columns is not really the biggest vehicle you can lift. It ...

BendPak PCL-18B-8, Low Voltage — the Eight-Column Set for a Standard Shop Supply This package exists for a specific and very practical reason:...

BendPak PCL-18B-6 Mobile Column Lifts, Set of Six The PCL-18B-6 is a six-column mobile lifting system for three-axle trucks, buses, refuse veh...

BendPak PCL-18B-6 — Six Columns, Built From Parts You Can Buy Here is the detail on this lift that almost no competing column set can match, a...

BendPak PCL-18B-4 Mobile Column Lifts, Set of Four — High Voltage The thing that separates these columns from a screw-drive mobile lift is whe...

BendPak PCL-18B-4 Mobile Column Lifts, Set of Four Four columns is the standard working set, and BendPak's cabling is the reason this configur...

BendPak PCL-18B-2 Mobile Column Lifts, Pair — High Voltage Read this first, because it is the thing most likely to cause a bad purchase: a pai...

BendPak PCL-18B-2 Mobile Column Lifts, Pair — Low Voltage The feature on these columns that nobody thinks about until they need it is the manu...

BendPak HDS-14LSXE: the alignment rack with thirty inches added, plus rolling jacks and the airline kit This is the long-wheelbase version of ...

BendPak HDS-14LSX package: one bay that does alignment and everything else Most shops that buy an alignment rack already own a service lift, a...

When it is down, the floor is just floor The SP-7XEF is the flush-mount member of this scissor family, and the whole argument for it is what y...

BendPak EVS4500 Mobile EV Battery and Powertrain Lift Table The detail that makes the EVS4500 an EV tool rather than a heavy scissor table is ...

A battery table that runs on its own battery The EVS3000 is a mobile scissor lift table for dropping and refitting electric-vehicle battery pa...

Anti-Vibration Pads: the maintenance a compressor most quietly needs A reciprocating air compressor spends its life trying to walk across your ...